Items where Division is " Engineering and Technology > Department of Mechanical Engineering" and Year is 2020

Up a level
Export as [feed] RSS 2.0 [feed] RSS 1.0 [feed] Atom
Group by: Creators | Item Type | No Grouping
Jump to: C | K | M | P | S | T | V
Number of items: 11.

C

Chaine, Sarat Chandra (2020) Investigation of Micro-drilling of Aerospace Materials: Modeling and Optimization. PhD thesis.

Chatterjee, Suman (2020) Experimental Investigation on Drilling and Welding of Engineering Materials using Laser. PhD thesis.

K

Koteswararao, D (2020) Dynamic Analysis and Active Control of Functionally Graded Rotor Shaft System. PhD thesis.

Kumar, Kamlesh (2020) Ti-6Al-4V alloy weld joint by variant of TIG welding method: Characterization and mechanical performance evaluation. PhD thesis.

Kumar, Manoj (2020) Numerical and Experimental Analysis of Cryogenic Turboexpander. PhD thesis.

M

Mohanty, Tapas Ranjan (2020) Investigations of Blast Furnace Cooling Staves and Intelligent Prediction Using Artificial Neural Network. PhD thesis.

P

Pandey, Krishna Kant (2020) Intelligent Trajectory Planning and Navigational Analysis of Wheeled Mobile Robot in Cluttered Workspace. PhD thesis.

S

Sahu, Sushanta Kumar (2020) An Investigation of Dissimilar Pipe Welding of AISI 304 Stainless Steel with CP Copper. PhD thesis.

Singh, Tej Pratap (2020) Heat Transfer and Fluid Flow Analysis of a Turbulent Jet Flowing Over a Sinusoidal Wavy Surface. PhD thesis.

T

Thrinadh, Jadam (2020) Experimental Studies on Machinability Assessment of Difficult-to-Cut alloys (Inconel 718 and Ti-6Al-4V) During Traditional and Non-Traditional Machining. PhD thesis.

V

Vaikunthbhai, Katariya Pankajkumar (2020) Nonlinear Structural Analysis of SMA Bonded Curved Skew Sandwich Composite Panel Under Hygro-Thermo- Mechanical Loading. PhD thesis.

This list was generated on Fri Jun 21 10:11:31 2024 IST.