Items where Subject is "Engineering and Technology > Mechanical Engineering > Hot Machining"

B

Bera, Tanusree (2019) Development and Characterisation of Metal Matrix Composite Using Cenosphere for Wear Resistant Applications. PhD thesis.

C

Chatterjee, Suman (2020) Experimental Investigation on Drilling and Welding of Engineering Materials using Laser. PhD thesis.

G

Goudhaman, J (2007) Experimental Investigation of Hot Machining Process of High Manganese Steel using Design of experiments by Taguchi Method. BTech thesis.

K

Kumar, Kamlesh (2020) Ti-6Al-4V alloy weld joint by variant of TIG welding method: Characterization and mechanical performance evaluation. PhD thesis.

P

Parida, Asit Kumar (2017) Heat Assisted Machining of Nickel Base Alloys: Experimental and Numerical Analysis. PhD thesis.

Pradhan , Pullak (2018) A Reduced Model of Higher Order Composite Rotor using Balanced Realization Technique. MTech thesis.

R

Ramana , Kukarasi (2018) Development of Cryogenic Helium Turboexpander. MTech thesis.

S

Sahu, Anshuman Kumar (2021) Performance Assessment of Rapid Tool Electrodes During Electrical Discharge Machining of Titanium and Its Alloy. PhD thesis.

Samal, Sangram Kumar (2021) Thermo-Hydrodynamics of Single-Phase and Two-Phase Flow Boiling in a Novel Design Recharging Microchannel Heat Sink. PhD thesis.

Shaibu, V.B (2021) Thermo-mechanical Investigation of Dissimilar Welding of AISI 304 Stainless Steel with Commercially Pure Copper. PhD thesis.

Singh, Abhishek Kumar (2018) Developent of Helium Re-condenser for 1.5 T ZBO MRI Scanner. MTech thesis.

Singh, Sandeep Kumar (2013) Simulation of R.F window Brazing process: Thermal-Structural analysis of ceramic to metal vacuum brazing joints. MTech thesis.

Singh, Shalini (2014) Experimental investigation and modeling of hot machining operation using high-strength material. MTech by Research thesis.

T

Thakur, Aruna (2016) Influence of Advanced Coated Tools on Machinability Characteristics of Incoloy 825. PhD thesis.

Thrinadh, Jadam (2020) Experimental Studies on Machinability Assessment of Difficult-to-Cut alloys (Inconel 718 and Ti-6Al-4V) During Traditional and Non-Traditional Machining. PhD thesis.

Tudu, Kapura (2017) Experimental Studies of a Direct Injection Diesel Engine Fuelled with Light Fraction Pyrolysis Oil-Diesel Blend. PhD thesis.

V

V B, Shaibu (2012) Numerical analysis of work roll cooling in hot rolling process. MTech thesis.

Vaikunthbhai, Katariya Pankajkumar (2020) Nonlinear Structural Analysis of SMA Bonded Curved Skew Sandwich Composite Panel Under Hygro-Thermo- Mechanical Loading. PhD thesis.