Items where Subject is "Engineering and Technology > Ceramic Engnieering"

Thesis

Abhinay, Sreeram (2015) Effect of Dispersant and Binder on Fabrication of BZT-0.5BCT Piezoelectric Wafers by Tape Casting Technique. MTech by Research thesis.

Adhikari, Prativa (2015) Effect of Different Nano-oxide Addition on Densification, Microstructure, Electrical and Mechanical Properties of Ba(Zr0.2Ti0.8)O3–0.5(Ba0.7Ca0.3)TiO3 (BZT–BCT) Ferroelectric Ceramics. MTech by Research thesis.

Anand, Rajan (2012) Electrophoretic deposition of hydroxy-apatite on Ti6Al4V. BTech thesis.

Bansal, Vinay (2010) Synthesis and Characterization of Sodium Potassium Niobate (Na0.5K0.5NbO3)–Nickel-Zinc Ferrite (Ni0.6Zn0.4Fe2O4)Composite. BTech thesis.

Biswal, S (2010) Preparation of Hydroxyapatite Porous Scaffold. BTech thesis.

Dhal, Amrit Abhishek (2012) Comparative study of properties of Barium Titanate synthesized by Solid State and Auto-combustion Method. BTech thesis.

Jani, P (2010) Development of CaF2 based Glass Ceramic. BTech thesis.

Jena, Preetam (2007) Synthesis and characterization of hydroxyapatite. BTech thesis.

K, Rohan (2007) Programming and simulation of densification of ZTA nano-composite. BTech thesis.

Khan, Nabid Anjum (2007) Enhanced phase stability of metastable tetragonal zirconia nanocrystals prepared through novel chemical routes. BTech thesis.

Kumar, Binit (2007) Multiferroic composites an overview. BTech thesis.

Kumar, Prashant (2011) Preparation and Densification study of Barium Zirconate (BaZrO3) nanopowders. BTech thesis.

Kumar, Vijay (2007) Phase formation process of citrategel derived hexagonal ferrite. BTech thesis.

Kundan, Paswan (2011) Sintering study of Mag-Al Spinel synthesized via combustion synthesis using glycine as fuel. BTech thesis.

Lenka, Abinash (2012) Effect of calcination temperature on kaolinite for mullitisation of kaolinite and alumina mixture. BTech thesis.

Majhi, Manoj Kumar (2011) Effect of span length on bending strength and Weibull modulus of sintered alumina bar. BTech thesis.

Miss, Jyoti (2017) Characterizations of Substituted Co2Y and Zn2Y type Hexagonal Ferrite. MTech thesis.

Mohapatra, Rohit (2010) Comparison of Physical Properties of Different Compositions of Alumina/Lanthanum Hexaaluminate Ceramic Composite. BTech thesis.

Mondal, Soumini (2016) Mg-Al Layered Double Hydroxide Nano-Carrier for Controlled Release of anti-inflammatory Drug. MTech by Research thesis.

Panda, Ashish Kumar (2012) Synthesis and Characterization of Calcium Phosphate-Alumina Composites. BTech thesis.

Patel, A (2010) Synthesis and Characterization of Multiferroic Composite (Barium Titanate Nickel Ferrite) by Solid State Route. BTech thesis.

Patra, Sunil (2009) Synthesis and Characterization of AND Lanthanum Doped by Auto-Combustion Technique. MTech thesis.

R, Vinaykumar (2020) Low Temperature Sintering and Characterizations of Co-Ti Substituted SrFe12O19 M-type Hexagonal Ferrites for High frequency Antenna Applications. PhD thesis.

Rout, Sarat Kumar (2015) Synthesis, Electrical and Electrochemical Behavior of Lanthanum Strontium Cobalt Ferrite for SOFC Cathode Application. PhD thesis.

Sahoo, Ganesh Kumar (2009) Synthesis and Characterization of BaTiO3 Prepared by Molten Salt Synthesis Method. MTech thesis.

Saxena, K (2010) Synthesis and Characterisation of Lead Free Piezoelectric NBT-BT Ceramic. BTech thesis.

Sharma, Antareep (2014) A comparative study between Direct Spinel Addition and In-Situ Spinelisation in a Low Cement High Alumina based Refractory Castable. BTech thesis.

Singh, Rupali (2016) Mullite Ceramic from Diphasic Precursor Powder. MTech by Research thesis.

Singh, Yogendra Pratap (2022) Preparation and Characterization of Freeze-Dried and Electrospun Scaffolds from Chitosan, Gelatin, and Monetite Nanoparticles for Bone Tissue Engineering. PhD thesis.