Items where Subject is "Engineering and Technology > Chemical Engineering > Heat Transfer"

Bal , Pramod Kumar (2013) Production of 500 Tons per Day of Pure Hydrogen Gas from Refinery Off-Gas Stream. BTech thesis.

Mohapatra, Sowhm Swain (2013) Production of Bio-fuel & Bio-char from Sugarcane Bagasse by Thermal Pyrolysis. MTech thesis.

Singh , Gaurav (2013) Implementation of Traditional and Non-Traditional Optimization Algorithms for Heat Exchanger Design. BTech thesis.

A

Ahmed, Shahnawaz (2013) Prediction of Bubbles and Drop Dynamics under Different Flow Situations and Phase Change: Lattice Boltzmann Study. MTech thesis.

B

Behera, Amulya Kumar (2013) Study On the Effect Of Various Catalysts For Biomass Gasification Process. BTech thesis.

Behera, Rashmi Ranjan (2015) Air Atomized Spray with Additives: A Novel Cooling Methodology for the Development of Nanosteel. BTech thesis.

Behura, Satya Soumendra (2013) Study of Heat Transfer Enhancement in Microchannels using
Computational Fluid Dynamics (CFD) Models. BTech thesis.

C

Chouhan, Dheeraj (2016) Role of Water Temperature in a Spray Cooling of a Hot Steel Plate at Different Initial Temperatures. MTech thesis.

D

Das, Amit Bikram and Gouda, Ranjit (2008) Some Experimental Studies on Heat Transfer Augmentation for Flow of Liquid Hrough Circular Tubes Using Twisted Angles and Tape. BTech thesis.

Dhanibabu, Talakala (2013) CFD Analysis for Heat Transfer Augmentation Inside Plain and Finned Circular Tubes with Twisted Tape Inserts. MTech thesis.

G

Gouda, Ranjit and Das, Amit Bikram (2008) Some experimental studies on heat transfer augmentation for flow of liquid through circular tubes using twisted angles and tapes. BTech thesis.

J

Jaishree, V (2010) Optimization of a multiple Effect Evaporator System. BTech thesis.

Johar, Gaurav and Hasda, Virendra (2010) Experimental studies on heat transfer augmenatation Using modified reduced width twisted tapes (RWTT) as Inserts for tube side flow of liquids. BTech thesis.

K

Kujur, Rajan Kumar (2015) Experimental Studies on Heat Transfer Aspects Using Circular [MS] Rods Insert With and Without Baffles. BTech thesis.

Kumar, Sudhanshu (2022) Computational Study of Magnetohydrodynamics-Based Heat and Mass Transfer Inside Enclosed Systems by Lattice Boltzmann Method. PhD thesis.

Kumar , Bhaskar and Das, Pratap Chandra (2007) Manufacture of urea. BTech thesis.

M

Mohapatra, Vivek Chandan and Sahu, Debashis (2007) Experimental studies on heat transfer augmentation using twisted aluminium taper clips and twisted tapes. BTech thesis.

N

Nath, K (2014) Use of multicomponent fluid for waste heat recovery using kalina cycle. BTech thesis.

P

Parida, Anshuman (2011) Fabrication and Experimental Studies of a Hybrid Flat Plate Solar Collector for Heating Pool Water. BTech thesis.

Patankar, Sagar (2016) Study of Jet Impingement Cooling Behaviour of Hot Steel Plate in Film Boiling Regime Using CFD. MTech thesis.

Pati, Akash Ranjan (2016) Enhancement of Heat Removal Rate in Film Boiling Regime by Spray Cooling with Sea Water. MTech thesis.

Patra, Shalini (2013) CFD analysis of heat transfer augmentation for flow through a tube using wire coil inserts. BTech thesis.

Patro, Jitendra Kumar and Malviya, Abhinav (2012) Experimental Studies on Heat Transfer Augmentation Using TMT Rods with and without Baffles as Inserts for Tube Side Flow of Liquids. BTech thesis.

R

Rangarajan, Raghuraman (2011) Design and Simulation of a Multiple Effect Evaporator System. BTech thesis.

Rastogi, Tulika (2014) Experimental studies on heat transfer augmenatation using galvanised iron wire insert with and without baffles. BTech thesis.

S

Sahu, Samir Kumar (2013) Experimental Studies on Heat Transfer Augmentation using Triangular Wavy Tape (TWT) As Inserts For Tube Side Flow Of Liquids. BTech thesis.

Sahu, Saurav Kumar (2011) Design of waste heat recovery system in a sponge iron plant. BTech thesis.

Sandha, Jasobanta (2013) Experimental studies on hydrodynamic behaviour of flow through a tube with Triangular Wavy Tapes (TWT). BTech thesis.

Sharma, Srinidhi (2011) Calculation of heat losses from NIT Rourkela’s swimming pool and a study on evaporative losses using MATLAB. BTech thesis.

Y

Yadav , Sunil (2013) Energy from municipal waste using a gasifier. BTech thesis.